The Acetylene Production Plants or also know as DA Gas plant from MOS TECHNO ENGINEERS are of indigenous manufacture. Every part has been carefully designed by experienced engineers. These DA Gas plant are made of the best material. Every part has been accurately made and carefully inspected before assembly. Each unit, after assembly, is charged and worked continuously to check its performance. You are, therefore, assured of an efficient and dependable acetylene plant. This Acetylene Plant from MOS TECHNO ENGINEERS is of an advanced design, incorporating several features not ordinarily found in other generators. This one is a fully automatic plant with twin hoppers (and needs an operators' attention for only ten minutes in an hour). All operations are performed by pneumatically controlled valves, assisted by highly sensitive sensors, integral with the temperature control instruments. These, in turn open the water inlet valve or residue drain valve etc. Two hydraulic pumps help to open and close the supply of calcium carbide. This is fed into the generator by screw feed conveyors. The screw feed mechanism and the agitator are operated by flame-proof motors and fittings.
The entire operation is perfectly synchronised to give maximum efficiency and simplicity in operation. Any failure, whether it is of power supply, water, instruments air, is signalled visually and also audibly when an alarm bell rings to alert the operator.
Only flame proof lights and electrical fittings according to IS2148-68 (Group II) or BSS-229 may be used in an acetylene plant building. Acetylene cylinders must be of specification IS: 7312: 1974 or ICC:8. The design of the entire plant has been made with safety in mind. Flash Back Arrestors, High Pressure Reverse Flow check valves, safety valves and complete gauging help protect both equipment and personnel. Various auto controls, safety valves, auto vent valves, nonreturn valves and Flash Back Arrestors are also provided to make this plant absolutely safe to operate in all conditions.